During the working of the printer all sorts of problems will appear, such as print head blockage,ink break fault
1.Add ink properly
Ink is the main printing consumables, high smoothness of original ink can print out the perfect image. So for the ink cartridges and ink refill is also a live technical system: choose high quality original ink manufacturer; Correct identification and add the right color ink, do not add the wrong color and ink mixed use; Add ink, you can use ink injection funnel or related adding ink refill tube auxiliary tools. Finally, in the work, must pay close attention to ink cartridge capacity at any time.
2.The ink viscosity and the relationship between print head blockage
For printing equipment, many problems caused by nozzle clogging , it is often because the ink viscosity changes. Ink viscosity is too high, making the mobility of ink, and during this time, out of ink quantity is not enough; Ink viscosity is too low, making the nozzle of the piezoelectric crystals easily inhaled air during recycling, and then the ink in this period of time, difficult to ink absorption, to suck out the air. In the two cases will need to pay attention to the environment of ink, before the use of ink, the ink is placed under the environment of the use is perfect more than 24 hours.
3.How to solve the problem of printer back to the ink?
Ink fault is a relatively common printing daily use fault, usually by the ink or in the ink for refill tube fittings and related problems caused by air pressure. Solution is to make three inspection, the inspection ink whether there is a leak, to prevent a large number of air into the atmospheric pressure, resulting in ink back flow of ink, back to the ink problems; The second is to check whether ink leak; Check the sealing contact with the interface for refill tube seal airtight, because for refill tube connected closely will not cause air into the ink system, cause the ink back flow phenomenon.
After checked out, if it is found that the interface is not sealed, can reconnect, ensure not leak sealing. In addition, it can be to install the check valve switch on for refill tube, etc.,
4.How to solve the ink break fault?
First confirm whether the cleaning effect is not good, the result is bad in every time always have broken ink, cleaning and broken ink is not fixed, appear this kind of problem, need to adjust the ink stack, and the position of the ink stack cap, in order to achieve a better cleaning effect; The other is a better cleaning effect, but the print start will appear a large area of broken ink color, and continue to print a row will be completely broken ink, this kind of situation is probably the cause of leak ink , need to check the copper set of interfaces and o-rings.
Second is there began a period of time after a break of ink, printing performance for broken ink jet is not much, several on a kind of color, this is mainly due to the ink cartridge front-end or refill tube with big bubbles. Need to check the refill tube whether there a large number of bubbles in the middle.Turned on again after the ink stack click turn in one direction.
Post time: Apr-12-2022